| ID | | Article Title | Post Date |
|
72 | 
| The Crescendo/Encore installer hangs, or crashes the system; occurs most often when run from the Sonnet installer CD. | May-12-09 |
|
76 |
| Which current Encore/ST G4 processor upgrades include a pre-attached heat sink? | May-12-09 |
|
77 |
| I purchased an Encore/ST G4 processor upgrade that is just a card; is it less reliable than one with a pre-attached heat sink? | May-12-09 |
|
169 |
| May I discard my original CPU after installing Sonnet's upgrade cards?
| May-07-09 |
|
171 |
| The speed indicated on the G3 or G4 chip on my Sonnet processor upgrade doesn't seem to match the speed of the upgrade I purchased. What's the story? | May-07-09 |
|
175 |
| The Crescendo/Encore installer hangs, or crashes the system; occurs most often when run from the Sonnet installer CD while using Mac OS 9. | May-07-09 |
|
176 |
| Sonnet OS X Installer Instructions | May-07-09 |
|
204 | 
| Mac OS 10.5 "Leopard" shuts down a few seconds into booting after a new installation of the OS. | May-07-09 |
| This problem has nothing to do with our processor upgrade being in the machine or with the firmware update that was done beforehand.
It has everything to do with how 10.5 was installed. Doing the 10.5 install as a simple "Upgrade" rather than using some of the other options like Archive and Install or Erase and Install.
When you do a straight upgrade, the installer just overwrites the old 10.4 System folder and that can leave some incompatible kernel extensions lurking in the new 10.5 folder whose response to that is to shut down on boot if it encounters something it doesn't like. So you need to do an Archive and Install of 10.5. This will create a new System folder, migrate your various user settings but it won't migrate any outdated stuff to the new folder.
|
| |
|
218 |
| The computer's standard startup process takes noticeably longer after upgrading to any Mac OS 9.x system from Mac OS 8.6 or earlier. | May-12-09 |
|
235 |
| After installing the Encore/ST G4 upgrade card, its speed is reported incorrectly. This occurs using Apple System Profiler (ASP), as well as other third party reporting utilities such as Xbench, Tech Tool, and others. | May-12-09 |
|
236 |
| After installing an Encore/ST G4 processor upgrade into my Power Mac G4 computer or upgrading to Final Cut Pro 4.0 (or later), a message stating, “The required hardware could not be found,” appears when I attempt to launch the application. | May-12-09 |
|
237 |
| After installing an Encore/ST processor card into my computer, it won't boot or it is very unstable. | Aug-06-09 |
| |
