| ID | | Article Title | Post Date |
|
72 | 
| The Crescendo/Encore installer hangs, or crashes the system; occurs most often when run from the Sonnet installer CD. | May-12-09 |
|
76 |
| Which current Encore/ST G4 processor upgrades include a pre-attached heat sink? | May-12-09 |
|
77 |
| I purchased an Encore/ST G4 processor upgrade that is just a card; is it less reliable than one with a pre-attached heat sink? | May-12-09 |
|
169 | 
| May I discard my original CPU after installing Sonnet's upgrade cards?
| May-07-09 |
| Sonnet recommends that you keep the original processor card even after installing our upgrade cards in case you ever need them. |
| |
|
171 |
| The speed indicated on the G3 or G4 chip on my Sonnet processor upgrade doesn't seem to match the speed of the upgrade I purchased. What's the story? | May-07-09 |
|
175 |
| The Crescendo/Encore installer hangs, or crashes the system; occurs most often when run from the Sonnet installer CD while using Mac OS 9. | May-07-09 |
|
176 |
| Sonnet OS X Installer Instructions | May-07-09 |
|
204 |
| Mac OS 10.5 "Leopard" shuts down a few seconds into booting after a new installation of the OS. | May-07-09 |
|
218 |
| The computer's standard startup process takes noticeably longer after upgrading to any Mac OS 9.x system from Mac OS 8.6 or earlier. | May-12-09 |
|
235 |
| After installing the Encore/ST G4 upgrade card, its speed is reported incorrectly. This occurs using Apple System Profiler (ASP), as well as other third party reporting utilities such as Xbench, Tech Tool, and others. | May-12-09 |
| Encore/ST G4 upgrade cards use processor chips from Freescale Semiconductor (formerly a division of Motorola). Currently, ASP and third party reporting utilities may not accurately calculate the bus multiplier used on some Encore/ST cards to achieve the processor\u8217 s rated speed. Because of this shortcoming, the utilities may report a processor speed of 0 MHz, or simply miscalculate the multiplier and come up with a number, for example, such as 667 MHz.
Mac OS 9 Users:
Use the latest version of Sonnet\u8217 s Metronome utility. It has been updated to accurately report the processor speed of the Encore/ST G4 upgrade card.
Mac OS X Users:
Update your system with the latest version of SonnetCache. It enables Apple System Profiler to accurately report the Encore/ST G4 upgrade card's speed. |
| |
|
236 |
| After installing an Encore/ST G4 processor upgrade into my Power Mac G4 computer or upgrading to Final Cut Pro 4.0 (or later), a message stating, “The required hardware could not be found,” appears when I attempt to launch the application. | May-12-09 |
|
237 |
| After installing an Encore/ST processor card into my computer, it won't boot or it is very unstable. | Aug-06-09 |
| |
