| ID | | Article Title | Post Date |
|
138 | 
| Unable to format hard drives after moving a Fusion storage system from a Mac to Windows computer. | Mar-23-10 |
| If you move your Fusion storage system from a Mac to a Windows computer system and try to format the disk using the Computer Management Console in Windows, the disk will show up as a GPT Protective Partition with no way to format it.
To properly format the disk, follow these steps:
1) Open a Command window (Start > Run > cmd), then start.
2) List your disks with list disk, then select the appropriate one with select disk X (with X the number of your disk as seen in the listing).
3) Issue a clean all command to erase all information on the disk. At this point you may be able to use the disk again from the management console;if not, continue with a create partition primary. |
| |
|
387 | 
| How do I replace a failed drive under warranty if I'm in a sensitive/classified environment and can't send the old one back? | Mar-23-10 |
|
450 |
| My storage shows 10% more capacity under OS X 10.6 than under OS X 10.5. Why? | Mar-24-10 |
| With Snow Leopard (10.6), Apple adopted the standard usage of terabyte (TB) which equals 1,000,000,000,000 bytes = 10-to-the-12th bytes. Hard drive manufacturers have always specified drive capacity with standard usage which will now match what Mac OS X reports.
WIth Leopard (10.5) and previous versions of Mac OS X, Apple used the binary interpretation of terabyte, (technically a tebibyte) = 1,099,511,627,776 bytes = 2-to-the-40th bytes. Windows also uses binary interpretation.
Under Snow Leopard, drive capacity will be shown per drive specifications. For example, under OS X 10.6, a 1TB drive will appear as a 1000 GB capacity drive (but under OS X 10.5 as a 909 GB capacity drive). For additional information see support.apple.com/kb/TS2419.
What does this mean in real terms? Do I get an immediate increase in storage space?
Formatting or actual capacity does not change at all, only the reported capacity because of the change from base-2 to base-10.
Should I reformat the drives before attempting to plug in a previously 10.5 formatted unit into a 10.6 machine or vice versa?
Reformatting is not necessary at all.
What happens if I plug a 10.6 formatted unit into a 10.5 machine or vice versa?
The volume is seen normally. It is completely compatible and can be transparently moved back and forth. |
| |
|
459 |
| The performance of my drive array is significantly less than I expect. | Jun-14-11 |
|
955 |
| Can I use Seagate Iron Wolf drives; or Hitchai and WD drives 8TB and larger? | May-31-18 |
| |
