Customer Service
Sonnet Logo
Customer Service
Products Where to Buy Store Support News & Media About Sonnet Partner Resources

Fusion Thunderbolt 3 PCIe Flash Drive
Please click the arrow next to the category to expand or collapse:
Driver (0)
Firmware (0)
Manual (1)
FAQ (7)
IDArticle TitlePost Date
891 After hot unplug/plug my HP ZBook gets a "Unable to load driver because a previous driver is still in memory" error.Jan-03-17
906 I'm getting low throughput on my Thunderbolt 3 device. Why could this be?Oct-05-17
942 Can I replace the M.2 module inside the Fusion Flash Drive?Sep-25-17
Unequivocally not!

For the following reasons:
1) An alternate SSD module would likely not fit. The internal heat sink case is milled with very tight tolerances for a specific SSD for efficient heat conduction.
2) Without customized heat sinking, an alternative SSD module would likely overheat.
3) An alternate SSD would likely unexpectedly disconnect in the middle of a write because of a power surge. Sonnet carefully chose and tested an SSD that does not exceed the Thunderbolt power limit. Most SSDs consume more power than Thunderbolt can support for a bus-powered device.
4) You may damage your computer.
5) You would void your warranty.
973 The Fusion Flash Drive is not showing up in Disk Utility on macOS 10.13.Mar-07-18
When Disk Utility is launched, you will notice a sidebar control icon in the upper left called "View", which is new to the macOS 10.13 version of Disk Utility. This initially defaults to the user-friendly "Show Only Volumes", even if launched from a window stating "The Disk You Inserted Is Not Recognized by This Computer", and you click "Initialize..." A new Fusion Thunderbolt PCIe Flash Drive is not formatted, so it is not yet a volume and it does not appear in a Show-Only-Volumes sidebar.

Select "Show All Devices" from the sidebar View control icon. (We don't know why you would ever select "Hide Sidebar".)

In 10.13.1, changing View mode to "Show All Devices" does not initiate a rescan for devices, so you must quit and relaunch Disk Utility, and then the Fusion Flash Drive will show up. (Disk Utility remembers the "Show All Devices" mode.)

Apple has fixed this anomoly in 10.13.2+, where a rescan is for devices is performed when you change Show modes. With 10.13.2+, one will not need to quit and relaunch Disk Utility, just change the mode to "Show All Devices".
1021 Can I connect the Fusion Thunderbolt 3 Edition PCIe Flash Drive to a Thunderbolt 2 Mac?Jul-23-18
1043 My computer is not recognizing the Fusion Thunderbolt 3 Flash Drive deviceDec-15-18
1045 Upon connecting the Thunderbolt 3 Fusion Flash Drive, I see an error message "Accessory Needs More Power"Dec-18-18

Copyright © 2016 Sonnet Technologies, Inc. All rights reserved. | Trademarks