| ID | | Article Title | Post Date |
|
120 | 
| How do I set up a RAID 0 striped array under Windows XP Professional or Vista? | Mar-23-10 |
|
121 |
| Can I set up a RAID 1 mirrored array under Windows XP or Vista? | Mar-23-10 |
|
124 |
| Fusion F2 LEDs do not come on when device is connected into power source. | Aug-05-09 |
|
125 | 
| Fusion F2 does not appear to sleep. The lights on the front panel remain on. | May-07-09 |
| When the computer is put to sleep, the drives in the Fusion F2 also spin down and sleep. However, the blue LEDs on the front of the Fusion F2 will remain on to indicate the Fusion F2 is still connected to a power source. |
| |
|
138 |
| Unable to format hard drives after moving a Fusion storage system from a Mac to Windows computer. | Mar-23-10 |
| If you move your Fusion storage system from a Mac to a Windows computer system and try to format the disk using the Computer Management Console in Windows, the disk will show up as a GPT Protective Partition with no way to format it.
To properly format the disk, follow these steps:
1) Open a Command window (Start > Run > cmd), then start.
2) List your disks with list disk, then select the appropriate one with select disk X (with X the number of your disk as seen in the listing).
3) Issue a clean all command to erase all information on the disk. At this point you may be able to use the disk again from the management console;if not, continue with a create partition primary. |
| |
|
346 |
| What is the voltage specification of the Fusion F2? | Jun-22-09 |
|
450 |
| My storage shows 10% more capacity under OS X 10.6 than under OS X 10.5. Why? | Mar-24-10 |
|
459 |
| The performance of my drive array is significantly less than I expect. | Jun-14-11 |
| |
